From initial design and specification of a continuous emissions monitoring system (CEMS) to QA/QC planning, certification tests and reporting or even installing and operating temporary systems to collect data for Predictive Emissions Monitoring Systems (PEMS) development, CleanAir’s team of professionals are ready to assist you with your continuous emissions monitoring requirements. CleanAir provides a full range of services to all types of industries as follows.
Whether you are considering the advantage of CEMS versus PEMS monitoring or are challenged with implementing mercury monitoring, our staff of engineers and consultants is uniquely qualified with extensive experience to provide:
CleanAir performs all certification tests as required by state or federal regulations. These could include:
Our experience indicates a 3D pitot traverse can measure flow rates that compare with stoichiometric calculations and can be up to 15% lower than that of comparable S-type pitot traverse. To minimize this reported positive flow bias associated with EPA Method 2 test procedures (S-type pitot tube), CleanAir provides the following 3-D flow testing services:
In cases where a CEM system is needed for a limited time, such as the development of Predictive Emissions Monitoring Systems (PEMS) or for a short duration project, rental of a temporary system may be a cost effective solution. Systems can be integrated and installed based on traditional CEMS technology or Fourier Transform Infrared (FTIR) with remote monitoring and diagnostics.